Robertshaw 9420 Bedienungsanleitung

DIGITAL NON-PROGRAMMABLE THERMOSTAT9420HEAT PUMPHNeW2 Heat / 2 Cool User's ManualQuick StartInstallationApplicationThe Robertshaw 9420 is a multi

10 WIRINGOPENINGReset Switch◆ ResetTo reset the thermostat press the RESET button located just below thelower left corner of the display.Step 5: Trou

Two Year Limited WarrantyClimate Controls Americas warrants to the original contractorinstaller, or to the original consumer user, each new Robertshaw

NOTES12

IMPORTANT SAFETY INFORMATION WARNING:• Always turn off power at main fuse or circuit breaker panel beforeinstalling, removing, cleaning, or servicing

Recycling ThermostatIf this thermostat is replacing a thermostat that contains mercuryin a sealed tube, do not place your old thermostat in the garbag

5. Place thermostat against the wall at desired location. Make sure wireswill feed through opening (Figure 4) on base of thermostat. 6. Mark placemen

5Typical heat pump with cool active reversing valve and auxiliary/emergency heat.Typical heat pump with heat active reversing valve and auxiliary/emer

15. Replace thermostat cover by snapping into place.16. Turn on power to system. Test thermostat as described in the following section.Step 3: Testing

7NOTE: ONCE THE THERMOSTAT TURNS OFF, A BUILT IN 5-MINUTE DELAY PREVENTS THE SYSTEM FROM TURNING ON AGAIN. THIS PROTECTS THE COMPRESSOR. NO ADDITIONA

Step 4: Customizing the Thermostat◆ SettingsSystemCool: The thermostat controls the cooling.Off: The heating and cooling systems are off.Heat: The the

9◆ Temperature Differential 2ndStage DelayThe temperature differential is factory set at 1.0°F (.5°C) for the 1st stagedifferential and 2°F (1°C) for