Robertshaw RS6220 Installationshandbuch PDF herunterladen (Seite 10)

Default EnergyStar™ Settings for RS5000 and RS6000

The RS5110, RS5220, RS6110 and RS6220 are programmable thermostats

and are preprogrammed with a schedule that is recommended by

EnergyStar™. The schedule is designed to lower energy costs year-round.

Setting Time and Day for RS5110, RS5220, RS6110

and RS6220

To adjust the time and day settings press the SET TIME button. The hour will

flash. To change the settings:

1. Use the and buttons to change the flashing number.

2. Press the SET TIME button to move through hours, minutes and days

of week.

3. Make changes as needed. They will be saved automatically.

NOTE: THE THERMOSTAT WILL NOT CORRECT FOR

DAYLIGHT SAVING TIME.

Installation Test Utility

WARNING: The installation test procedures can damage the

heating/cooling equipment if used incorrectly. These procedures should only

be performed by trained HVAC personnel.

The following instructions may be used to test the heating/cooling system for

correct function.

To enter the test mode press and hold and for ten seconds.

While in test mode, only the , and Start/Stop Schedule buttons

are active.

Short Cycle protection is disabled when using the test utility.

Push the Start/Stop schedule button at any time to exit test mode.

In the test mode:

Press to force the fan on or off. The fan icon will rotate. If the selector

switches are set for NON-HP and GAS, the fan icon will not be displayed.

Pressing repeatedly will allow testing of the system modes. See

following tables. The display will show appropriate animated icons.

EnergyStar™ Temperature Settings

Winter (Heating) Summer (Cooling)

Morning (6:00 am) 70°F (21°C) 78°F (25°C)

Day (8:00 am) 62°F (17°C) 85°F (29°C)

Evening (6:00 pm) 70°F (21°C) 78°F (25°C)

Night (10:00 pm) 62°F (17°C) 82°F (28°C)

1 2 ... 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Robertshaw RS6220 Installationshandbuch Seite 10